VW Corrado 1989-1992

Volkswagen Corrado gauge panel installation instructions for adding additional gauges to the center console.

This double gauge panel can be installed by press fit or by fabricating simple brackets for a more secure installation.

Corrado Gauge Panel — The installation of the Corrado gauge panel requires a little bit of DIY by the installer. The project was shelved prior to completing mounting brackets. The panel could be simply press fit in to the console, but our recommendation is to make it more secure.

There are two screw holes in the panel intended for mounting purposes. Attach two L-brackets made of sheet metal, or a block of plastic, to the console with double faced tape or epoxy. Then drill two mounting holes with the gauge panel held in place. Secure the panel with self tapping or sheet metal screws.

Corrado Gauge Panel — The gauge panel fits approximately where the mold line is inside the console.

Corrado Gauge Panel — The gauge panel fits approximately where the mold line is inside the console.

Corrado Gauge Panel — Front view of classic VDO gauges attached to panel. The panel is designed for 2-1/16″ diameter gauges.

Rear view of classic VDO gauges attached to panel — Gauges attach to panel with their brackets.

Corrado Gauge Panel — Press fit installation.

Presss fit installation — Press fit installation.

BUY YOUR GAUGE PANEL NOW!

Learn more about the Volkswagen Corrado:
DriversFound.com